Intended for light coloured models only.
Please note I am unable to print checkers to the shoulder pad sizes and if you are adding checks they need to be painted around the circle when the transfer is flat and sealed in. The red will now show up over black pre-painted checks.
Squad Markings Sold Separately
Approximate icon measurements are
6mm
8mm
10mm
15mm
Please note these are made to order and have to be printed and sealed which can take a while of course, these are not pre-made ready to ship so please be patient.
Directions for use
1) Gloss varnish the area of the miniature you’d like to apply the transfer to first.
2) Wait for the gloss to dy.
3) Cut around the icon as close as possible to fit on the miniature area, these are not pre-cut.
4) Soak the decal in water for a few seconds, if you over soak the transfer the ink may bleed.
5) Gently lift off the transfer with a brush and apply it onto the model
6) Position the decal how you want it on the model
7) Allow it to fully dry
8) Apply thin coats of decal softener like Microsol / Set letting it dry in-between coats until the edge is flat and no bubbles are visible.
9) Seal in the finished model with a varnish of your choice
Intended for light coloured models only.
Please note I am unable to print checkers to the shoulder pad sizes and if you are adding checks they need to be painted around the circle when the transfer is flat and sealed in. The red will now show up over black pre-painted checks.
Squad Markings Sold Separately
Approximate icon measurements are
6mm
8mm
10mm
15mm
Please note these are made to order and have to be printed and sealed which can take a while of course, these are not pre-made ready to ship so please be patient.
Directions for use
1) Gloss varnish the area of the miniature you’d like to apply the transfer to first.
2) Wait for the gloss to dy.
3) Cut around the icon as close as possible to fit on the miniature area, these are not pre-cut.
4) Soak the decal in water for a few seconds, if you over soak the transfer the ink may bleed.
5) Gently lift off the transfer with a brush and apply it onto the model
6) Position the decal how you want it on the model
7) Allow it to fully dry
8) Apply thin coats of decal softener like Microsol / Set letting it dry in-between coats until the edge is flat and no bubbles are visible.
9) Seal in the finished model with a varnish of your choice
