Pack Markings Sold Separately
These are more expensive than my usual sheets as I am using a special printer with another supplier that can make transfers to go over any colour and can also be printed in white or metallics, my regular sheets for dark over light I don't use this printer for, this process also takes a bit longer to do so please be patient.
Approximate icon measurements are
6mm
8mm
10mm
15mm
Please note these are made to order and have to be printed and sealed which can take a while of course, these are not pre-made ready to ship so please be patient.
Directions for use
1) Gloss varnish the area of the miniature you’d like to apply the transfer to first.
2) Wait for the gloss to dy.
3) Cut around the icon as close as possible to fit on the miniature area, these are not pre-cut.
4) Soak the decal in water for a few seconds, if you over soak the transfer the ink may bleed.
5) Gently lift off the transfer with a brush and apply it onto the model
6) Position the decal how you want it on the model
7) Allow it to fully dry
8) Apply thin coats of decal softener like Microsol / Set letting it dry in-between coats until the edge is flat and no bubbles are visible.
9) Seal in the finished model with a varnish of your choic
Pack Markings Sold Separately
These are more expensive than my usual sheets as I am using a special printer with another supplier that can make transfers to go over any colour and can also be printed in white or metallics, my regular sheets for dark over light I don't use this printer for, this process also takes a bit longer to do so please be patient.
Approximate icon measurements are
6mm
8mm
10mm
15mm
Please note these are made to order and have to be printed and sealed which can take a while of course, these are not pre-made ready to ship so please be patient.
Directions for use
1) Gloss varnish the area of the miniature you’d like to apply the transfer to first.
2) Wait for the gloss to dy.
3) Cut around the icon as close as possible to fit on the miniature area, these are not pre-cut.
4) Soak the decal in water for a few seconds, if you over soak the transfer the ink may bleed.
5) Gently lift off the transfer with a brush and apply it onto the model
6) Position the decal how you want it on the model
7) Allow it to fully dry
8) Apply thin coats of decal softener like Microsol / Set letting it dry in-between coats until the edge is flat and no bubbles are visible.
9) Seal in the finished model with a varnish of your choic
